Creating a beautiful mosaic needs good planning and careful work. You choose a Wedi Board for strong and neat results. This guide shows how to get the edges ready and set up the board so that your mosaic looks well done.
Understanding Wedi Board
Wedi Board stands as a light, waterproof base. It comes from tiny foam beads that get a hard cement coat. Many tilers use it in wet parts of the home like baths and kitchens.
Key Benefits of Wedi Board
- Water Protection: Stops water from getting through. This helps to block mold and mildew.
- Light and Simple: Makes moving and placing the board quite easy.
- Heat Holding: Keeps floors warm when heated.
- Many Uses: Works on walls, floors, or ceilings.
Preparing the Edges of Wedi Board
Getting the edges ready is very important for firm tile work. Follow these steps to prepare your board.
1. Cut the Board Accurately
Cutting must be neat. Use a straight edge and a sharp knife. Mark your line and press strong, then break the board along that mark. This keeps the edges smooth and helps you avoid extra sanding.
2. Sanding the Edges
After you cut, you might see rough parts. Rub these parts gently with fine sandpaper. This smooth move helps the tile glue stick well later on.
3. Seal All Joint Edges
The board joins need to stay dry. To do this, use Wedi’s sealing tape. Spread a good layer of joint glue along the edges. Then, press the seal tape on the glue. This step locks the joins and gets them ready for tiles.
Installing Wedi Board
Once the edges are ready, it is time to place the boards.
1. Choose the Right Glue
Pick a thin-set mortar that works with foam. Not each glue fits Wedi Board. Check the guide to be sure.
2. Applying the Adhesive
With a trowel that has teeth, spread the glue evenly on the wall or floor. The trowel size should match your tile size.
3. Positioning the Wedi Board
Place the board on the glue. Press the board in well and use a level to keep it straight. Press down to push out any trapped air.
4. Securing the Boards
For big sheets, you might add screws or fasteners. Push the screw heads in a bit so that they do not stick out later.
5. Finishing Edges and Joints
After sticking the board, redo the joints with glue and tape. Do this where the board meets water directly.
Tiling Over Wedi Board
Now, you can put tiles over your set Wedi Boards. Tiling here follows the usual steps but comes with clear wins:
- Easy Cutting: You can cut the board to follow careful mosaic designs.
- Short Weight: The board is light. This lightness helps keep pressure low on the base.
Conclusion
Getting your Wedi Board ready and set right is key for strong mosaic surfaces. Follow these steps, and you will enjoy a finish that stays over time. Whether you have done many projects or this is your first, knowing how Wedi Board works will add to your work and make your mosaic shine.
